ISO INTERNATIONAL STANDARD 22215 First edition 2006-01-15 Fine ceramics (advanced ceramics, advanced technical ceramics) Test method for tensile creep of monolithic ceramics CeramiquestechniquesMethodesd'essai pourlefluage entraction desceramiquesmonolithiques Reference number ISO 22215:2006(E) @ISO 2006 hout license from IHS Not for Resale ISO 22215:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, ISO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Copyigh Intematilnal organization for Standardzation @ ISO 2006 All rights reserved d without ficense from IHS Not for Resale ISO22215:2006(E) Contents Page Foreword 1 Scope 2 Normative references 3 Terms and definitions. 4 Principle... 5 Apparatus. 6 Testspecimen. 7 Procedures. 8 Determination of the results.. 9 Test report. Bibliography ii nse wit license from IHS Not for Resale ISO22215:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO22215waspreparedbyTechnicalCommitteeISO/TC206,Fineceramics @ ISO 2006 - All rights reserved Copyright Inten onalOrganizationforStandardizatior Not for Resale INTERNATIONALSTANDARD ISO22215:2006(E) Fine ceramics (advanced ceramics, advanced technical ceramics) Test method for tensile creep of monolithic ceramics Scope 1 This International Standard specifies the test method for determining the tensile-creep strain and creep rupture time under uniaxial constantforce of monolithic fine ceramics and whisker or particulate-reinforced ceramic composites at high temperatures.This test method may be used for material development, material comparison, quality assurance, characterization and design data generation. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments)applies. Iso3611,Micrometercallipersforexternalmeasurement ISO 4287,Geometrical Product Specifications(GPS)-Surface texture:Profilemethod-Terms, definitions andsurfacetextureparameters Iso7500-2,Metallic materials-Verification of static uniaxial testing machines-Part 2:Tension creep testingmachinesVerificationoftheforceapplied Iso 9513, Metallic