ISO INTERNATIONAL STANDARD 18652 First edition 2005-02-01 Building construction machinery and equipment External vibrators for concrete Machinesetmaterielspourlaconstructiondesbatiments-Vibrateurs externespourlebéton Reference number ISO 18652:2005(E) @ISO2005 ISO18652:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56: CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland !! IsO2005-All rightsreserved ISO 18652:2005(E) Contents Page Foreword 1 Scope 2 Normative references. 3 Terms and definitions 4 Classification 5 Structure. 6 Performancerequirements 7 Instruction handbook 8 Testmethods 6 Inspectionandevaluation. 9 10 Designation. 11 Indicationontypeplate. 12 Commercialspecifications.. 10 AnnexA(informative)Structuresand dimensional characteristics ofexternal vibrators Examples. .20 AnnexB(normative)No-loadand loadtestsforexternalvibratorsInsulators Bibliography 23 ISO 18652:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO International Electrotechnical Commission (IEC) onall matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75% of the memberbodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO18652was prepared by Technical Committee ISO/TC195,Building construction machinery and equipment. 1S0.2005- ISO 18652:2005(E) INTERNATIONAL STANDARD Building construction machinery and equipment External vibrators for concrete 1 Scope This International Standard defines terms and specifies the classification, performance requirements,test as "vibrators"). It is applicable only to those power-driven external vibrators used for compacting concrete mix by vibration from the outside. NOTE The use of external vibrators consists in their attachment to forms, vibration stands, vibration tables, surface vibrators and vibrating beams in order to compact the concrete mix. 2Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Iso2398:1995,Rubberhose,textile-reinforced,forcompressedair—Specification Iso4414:1998,Pneumaticfluidpower—Generalrulesrelatingtosystems Iso6150:1