ISO INTERNATIONAL STANDARD 17454 First edition 2006-02-01 Plastics piping systems Multilayer pipes Test method for the adhesion of the different layers using a pulling rig Systemesde canalisationsenplastiques-Tubesmulticouches- Methode d'essai de I'adherence des differentes couches utilisant un anneaudetraction Reference number ISO 17454:2006(E) @ISO 2006 ISO17454:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation the unlikely event that a problem relating to it is found, please infom the Central Secretariat at the address given below. ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2006 - All rights reserved ISO17454:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. Iso collaborates closely y with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO17454 was prepared by Technical Committee ISO/TC 138,Plastics pipes, fittings and valves for the transportoffluids,SubcommitteeSc 5,General properties of pipes, fittings andvalves ofplastic materials and theiraccessories-Testmethodsand basic specifications. @ IS0 2006 All rights reserved ii ISO17454:2006(E) Introduction In response to the worldwide demand for specifications, requirements and test methods for multilayer pipes. WG 16 of ISO/TC 138/SC 5 was created at a meeting held in Kyoto, Japan, in 1998.The working group then started drafting three test standards (including ISO 17454) for multilayer pipes: Iso17456,Plastics piping systems—Multilayer pipes — Determination of long-term hydrostatic strength; IsO17455,Plasticspipingsystems—MultilayerpipesDeterminationof theoxygenpermeabilityof the barrierpipe. Only multilayer pipes are dealt with in this International Standard and for these purposes cross-linked polyethylene (PE-X) as well as adhesives are to be considered as a thermoplastics material. iv @ ISO 2006 - All rights reserved INTERNATIONAL STANDARD ISO 17454:2006(E) Plastics piping systems Multilayer pipes - Test method for the adhesion of the different layers using a pulling rig 1 Scope This International Standard specifies a method for testing the adhesion between layers of multilay