ISO INTERNATIONAL STANDARD 15982 First edition 2002-11-01 Open end blind rivets with break pull mandrel and countersunk head AlA/AlA Rivets aveuglesa rupture de tige a corpsouvert, a tete fraisee-AlA/AlA Reference number ISO 15982:2002(E) ISO @ISO2002 Copyright Intemational Organization for Standardization without license from IHS Not for Resale, 12/19/2015 03:00:06 MST ISO15982:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISo 2002-Allrights reserved d without ficense from IHS Not for Resale, 12/19/2015 03:00:06 MST ISO15982:2002(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 15982 was prepared by Technical Committee ISO/TC 2, Fasteners Annex A of this International Standard is for information only. ii Copyriaht Inter a Not for Resale,1/19/215006MS INTERNATIONAL STANDARD ISO15982:2002(E) Open end blind rivets with break pull mandrel and countersunk headAlA/AlA 1 Scope This International Standard specifies dimensional and mechanical characteristics and application data for open end blind rivets with break pull mandrel and countersunk head, with an aluminium alloy body (AlA) and an aluminium alloy mandrel (AlA) and with nominal diameters, d, from 2,4 mm up to and including 6,4 mm. 2Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of isO and IEC maintain registers of currently valid International Standards. Iso3269:2000,Fasteners—Acceptance inspection Iso14588:2000,Blind rivets—Terminology and definitions IsO 14589:2000, Blind rivets—Mechanical testing Dimensions 3 3.1 General Symbols and designations of dimensions are specified in Iso 14588. 3.2 Rivet dimensions See Figure 1 and Table 1. 1