ISO INTERNATIONAL STANDARD 15637-2 First edition 2002-12-15 Holding fixtures of cylindrical abrasive sleeves- Part 2: Holding fixtures for stationary machines Porte-manchonspourmanchons abrasifs cylindriques- Partie2:Porte-manchonspourmachines fixes Reference number ISO 15637-2:2002(E) ISO ISO 2002 Copyright Intemational Organization for Standardization ISO15637-2:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is atrademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Casepostale56·CH-1211Geneva20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland CopyrhtiematonaOganzaonfo Standardaion IsO2002-Allrightsreserved 1/9972545001 nitted without license from IHS ISO15637-2:2002(E) Foreword IsO (theInternational OrganizationforStandardization)isa worldwidefederationof national standardsbodies (iso committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Attention is drawn to the possibility that some of the elements of this part of isO 15637 may be the subject of patent International Standard ISO 15637-2 was prepared by Technical Committee ISO/TC 29, Small tools, Subcommittee SC 5, Grinding wheels and abrasives. Part 1: Holding fixtures with shank for hand-held grinding machines Part2:Holding fixturesforstationarymachines ii Copyright Intemational Organizationfor Standardization_served tadarda rds 1/9972545001 No reproduction or networking permit itted without license from IHS INTERNATIONALSTANDARD ISO15637-2:2002(E) Holding fixtures of cylindrical abrasive sleeves Part 2: Holding fixtures for stationary machines 1 Scope This part of ISO 15637 applies to holding fixtures for use with cylindrical abrasive sleeves with D > 100 mm in accordance with IsO 242i:These holding fixtures clamp the cylindrical abrasive sleeves using different systems, e.g.with a lamellar core or using a pneumatic system,which are used on stationary grinding machines. 2Normativereference The following normative document contains provisions which, through reference in this text, constitute provisions of this part of isO 15637. For dated references, subsequent amendments to, or revisions of, this publication do not apply.However,partiestoagreementsbasedonthispartofisO15637areencouragedtoinvestigatethepossibility of applying the most recent edition of the normative document indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid InternationalStandards.