ISO INTERNATIONAL 15547-2 STANDARD First edition 2005-11-01 Petroleum, petrochemical and natural gas industries Plate-type heat exchangers Part 2: Brazed aluminium plate-fin heat exchangers thermiquesaplaques Partie2:Echangeursthermiquesaplaquesenaluminiumbrasé Reference number ISO 15547-2:2005(E) @ISO2005 Copyright Intemational Organization for Standardization Not for Resale ISO 15547-2:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, ISO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Copyigh Intematilnal organization for Standardzation @ ISO 2005 - All rights reserved tted without license from IHS Not for Resale ISO15547-2:2005(E) Contents Page Foreword. IV Introduction 1 Scope 2 Terms and definitions 3 General... 4 Proposal information required.. 5 Drawingsandotherdata requirements 6 Design.. 7 Materials 8 Fabrication.. .8 6 Inspection and testing.. 10 Preparation for shipment.... AnnexA(informative)Recommendedpractice. Annex B(informative)Plate-fin heat exchanger checklist.. Annex C (informative) Plate-fin heat exchanger data sheets. Bibliography... ili se from IHS Not for Resale ISO 15547-2:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75% of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO15547-2 was prepared by Technical Committee ISO/TC 67, Materials, equipment and offshore structures systems This first edition of ISO 15547-2, together with ISO 15547-1, cancels and replaces ISO 15547:2000, of which it constitutes a technical revision. Iso 15547 consists of the following parts, under the general title Petroleum, petrochemical and natural gas industriesPlate-typeheatexchangers: Part1:Plate-and-frameheatexchangers Part2:Brazedaluminiumplate-finheat exchangers ISO 2005 - All rights reserved onalOrganizationforStandardizatior Not for Resale ISO 15547-2:2005(E) Introduction Some of the requirements within this part of isO 15547 have been extracted from the standards of the brazed aluminium plate-fin heat exchanger manufacturers'association (ALPEMA) may be particularly applicable where there is an innovative or developing technology. Where an alternative is A bullet () at the beginning of a clause or subclause indicates a requirement for the purchaser to make a decision or provide information (for information, a checklist i