ISO INTERNATIONAL STANDARD 15201 First edition 2006-09-15 Zinc and zinc alloys Castings - Specifications Zincetalliagesde zincPieces mouleesSpécifications Referencenumber ISO15201:2006(E) @ISO 2006 Not for Resale ISO15201:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISo 2006All rights reserved d without license from IHS Not for Resale ISO15201:2006(E) Contents Page Foreword. IV 1 Scope 2 Normative references 3 Terms and definitions 4 Casting designation... 5 Manufacture 6 Ordering information 7 Requirements. 8 Sampling. 9 Chemicalanalysismethods... 10 Marking and labelling . 11 Inspection document.. Annex A (normative) Recycling mark. Annex B(informative)Relationshipbetween thealloy designations used in this International Standard and the corresponding designations used in a number of countries... Annex C (informative) Properties of zinc-alloy die castings at 2o c Bibliography ii ense from IHS Not for Resale ISO 15201:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 15201 was prepared by Technical Committee ISO/TC 18, Zinc and zinc alloys, Subcommittee SC 2, Zinc alloys for casting. @ ISO 2006 - All rights reserved onal Organization for Standardizatior Not for Resale INTERNATIONAL STANDARD ISO 15201:2006(E) Zinc and zinc alloys Castings Specifications Scope 7 ThisInternational Standard specifiesthedesignation,chemicalcomposition,markingand other requirements for zinc alloy castings, produced by pressure die, permanent mould or sand casting, or another casting process. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including anyamendments)applies. IsO301,Zincalloyingots intendedforcasting Iso7000:2004,Graphicalsymbolsforuseonequipment—Indexand synopsis EN10204,Metallicproducts-Typesof inspectiondocuments 3 Terms and definitions For the purposes of this document, the following terms and definitions apply 3.1 pressure die casting metal object produced by injecting molten metal under high pressure and high velocity into a metal di